REFRESHER
PRODUCT INFORMATION

GENERAL DESCRIPTION

Junckers Refresher is a quick drying maintenance product for wooden floors treated with one of Junckers water-based lacquers or for Junckers solid hardwood floors prefinished with lacquer.  

The product is water-based, ready to use and is easily applied with a flat mop. A simple way to revive a dull looking surface, hide minor scratches and protect the floor in the period between professional recoats.

Use the Refresher in private homes and in commercial areas like offices or retail.

If the floor is to be re-lacquered at a later point, it is not necessary to remove the Refresher-treated surface. Only a light sanding is necessary before a new coat of floor lacquer.

For professional and private use.

DIRECTIONS FOR USE

The lacquered surface must be clean, dry, free from dust, grease, and soap residues.
Oiled, waxed, or polished floors are not suited for treatment with Refresher.

• Mix Junckers SylvaNeutralizer with warm water and wash the floor. Then leave the floor to dry.

• Wet a a flat thick-piled microfiber floormop in warm water and wring out the mop hard.

• Mount the mop to the mop base and spray a thin S-shaped line of Refresher directly onto the floor.

• Use the mop to spread the Refresher and make sure to work in the longitudinal direction of the floorboards. 

• Apply in an even layer and work in small sections of 3-4  m².

• Remember to keep overlaps between the individual sections moist.

• Always apply Refresher on the entire floor area to ensure a uniform appearance and gloss level.
• Leave the floor to dry for 1-2 hours before walking on the floor.
• If the floor is very worn, re-treatment can be conducted after 3 hours.
• Wait 24 hours to place furniture and lay out rugs.

Before treatment of the full floor, it is recommended to conduct a trial application in an inconspicuous area. After drying check the appearance of the floor and adhesion by scraping the surface with the edge of a coin.

If the lacquered surface is worn through to bare wood:
Refresher cannot not be used if parts of the existing lacquer surface is worn through to bare wood. In this case the floor must be sanded and re-lacquered.